By Emma François, last updated at 2011-07-7
Place the new gasket on the supply valve and start the new hand to avoid cross-threading. Tighten the power valve with a wrench and reposition the valve cover supply and hand tighten the screws. Then tighten with a screwdriver. Yu are done.
Use a wrench to loosen and remove the supply valve Compare new or old power valve to ensure the correct replacement.
"と私はあまりハーダウェイの歌詞を行うことができます。"
Using the carburetor diaphragm type valve, the supply valve is located within the wall of the fuel in the main metering block. Remove the fixing screws of the cover supply valve.
Do not remove the spring which is below the power piston. Clean the outside of the power piston and the measuring rod with a carburetor cleaner coating removers. Clean the piston at the same time. At that time, go ahead and rebuild the carburetor. Replace the air horn attached.
そしてすべてのあなたは気にQAS 、誰かを望んでいた
To replace the supply valves on carburetors that use the supply valve piston or rod counter, remove the carburetor air horn, remove the seal and Mr. Horn local and the power piston metering rod out of its position.
Check your car's carburetor power can deliver fuel to the engine when carrying heavy loads. Without it, your car will not be able to carry loads, because it will stop. Just follow the steps below to repair the valve of the carburetor of your electric car.
Related sites that may be useful:
0 件のコメント:
コメントを投稿